This item was presented to me with no holes drilled. It was my duty to select which stone went where. Many areas of the Dolphin's body were created in a near-vertical position.
These two CAD renderings display the many details of where each diamond must be placed and finally set.
I placed this item on green branches in front of my home to give this item more colour.
This 'shared claw' pendant was challenging for me as there were only 2 mini-claws per stone. If one claw was broken, then it was up to my jeweller to repair it a.s.a.p.
These sections took me all week just to set these stones. There was much eyestrain on me while I was working on it. I used a "156C", 90-degree angle bur to drill for EACH stone. The whole pendant of assorted pieces was a long process.
For the round disk shown below, I was given 9 of these to be made into a necklace/pendant.
The inside of these rings is aptly named "AZURE", and were all created with CAD.
No comments:
Post a Comment