Up close 'HAMMER ANVILS' => 15 photos

 In this special essay, I will explore only the 'Reciprocating Hammer anvil' and then show the final stone-setting results.

                      =============================

  The new 'coloured' anvil can be purchased at any tool supply company. But it is up to you, the stone setter, to fashion the shape to your setting needs.

 My anvil was contoured specifically for "Flush" stone setting. This is why the tip has been shaped with 'exacting proportions'. After a few months of setting, I will file the edges to a rectangular shape again. I prefer a #4 (Fine) or a #2 (Medium) texture file.

The anvil on the right is the basic design, and on the left is the 'ready-to-use' anvil.

The 'hole in the anvil' is used to insert a little bur, as this will greatly assist you in turning to tighten or remove the anvil.

 

  After tightening the anvil, I always smooth the anvil top & sides with a #600 grit Polishing Paper.

            

 A pair of pliers will help me grasp the anvil on the Reciprocating Hammer.

 After many months of (filing) trimming the anvil, exchange it for a newer tip. 

 If by any chance the tip gets loosened from constant use (this might occur), PLEASE TIGHTEN THE ANVIL SECURELY.

 This gnurled section of the handle adjusts the tension (or impact strength) as required.

 Gemstone setting results:

We are aiming for a smooth surface, always be watchful that the anvil hits exactly where it is needed.

   Do you see any rough texture from the anvil?

 This is my favourite photo of what a great hammer anvil will do to your gemstone setting.